What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
10.06.2025 06:29

the problem then depends on "how fast does the fuse operate?".
The third is lightning and “how it gets conducted into a home.”
One
Two Ocean Bands Are Warming Faster Than Ever — What This Means for Our Climate - The Daily Galaxy
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
This is 'the assistant's answer'
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
These devices are installed between the “hot” and “neutral” and protective ground.
2024–10–16 [ OO OLAOYE OYEBODE ]
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
Procter & Gamble to cut 7,000 jobs as part of broader restructuring - CNBC
The bolt then partially travels down the line to your home.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
a photo is worth a thousand words.
The other is “what does a “fuse” do?”
One is “what exactly is in a ‘surge protector’ ? ”
He then describes Rainy Season and Lightning.
Can we state Alia Bhatt as the most versatile actress in Bollywood now?
so, what happens?
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
How do I develop the patience to read books?
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
It also is a device that limits the change in current flow.
Now when you have a certain ac resistance, then a current flows in a loop.
What are 5 ways that can be done by the community to improve the public transport system?
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
Barnstars:
Here is a simplified AC power diagram.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
Can the fuse protect the electronic devices from lightning instead of a surge protector.
Big brands are staying quiet this Pride Month - CNN
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
but I think this circuit , shows a few more pieces.
It seems Mohan does not understand the difference between a comment and an Answer.
Beware: There’s a new Trump-RFK Jr. epidemic brewing - NJ.com
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
This is where this question deviates from being a 'generic' question, and becomes more specific.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Catch Jupiter and Mercury side by side in the evening sky this week - Space
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Because the load is inductive, the current lags the voltage.(by a bit).
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
Have you ever accidentally found out that you were about to be fired?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
This is the picture of an electronic coil of wire wound around a core of magnetic material.
There are three different concepts here that are getting confused.
2024–10–10[John johnson John Johnson ]
nine
This is where the MOV conducts again, and dissipated the energy.
What is lightning?
These are simplified answers to the original question, and does not change anything I wrote above.
An AC voltage/ current source, and an ac inductive load.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
The MOV will conduct when the voltage exceeds 50% of line voltage.
This device then solves the entire problem.
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
A circuit breaker is similar, but is resettable.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
What does a fuse do?
This one hit behind the barn.
In schematic diagrams this is the symbol for a fuse:
But… the neutral is now “floating” because of the 1 ohm resistance.
but this device (an Inductor) … impedes the rapid changes in the current.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
But it can get overloaded, and no longer works.
what exactly is a ‘surge’ protector?
I post the exact comment here.
He then describes the function of a fuse.
(Dc diagram shown, AC is similar).
At one ohm, the resistor has a maximum of 1 watt power.
[image of Common-mode choke]
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
There are two important concepts here.
Upvotes:
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
He then asserts :
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
[old diagram got deleted by accident]
At least they know the answer if they wanted it.
eight
A fuse is a non-resetable over current circuit protector.
For this case there are devices called Metal oxide varistors (MOV).
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
2024–10–14 [Omar Gharbi Omar Gharbi ]
Edit 2024–10.
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
First Sentence: